[diesel_mercedes] Re: Retrun spring in door latch.

?? not sure ~ are you asking about the outside door handle or the
latch proper ? .

Both are very simple to dismount & repair or replace with good used ,
you can easily swap the lock cylinder over if the handle is the fault .

Inner door panel must needs be removed for any of this however .

Have some aerosol glue ready to re - attach the plastic sheet again ,
you _don't_ want to leave this important piece off ! .

This is a _serious_ safety issue , I urge you to fix it quickly before
a disaster ocurrs .

-Nate
Lawrence wrote:
>
> I have a drivers door that you must return the latch by hand by
pulling on the door knob then letting go to reset the latch. I can
see inside where the spring is hanging I can sort of push it but is
that little hole on the side of the latch for a special tool to clip
the spring back on to its perch? I had it all apart but couldn't
seperate the door handle from the lock/latch. Lawrence Rhodes.......
>

Yahoo! Groups Links

<*> To visit your group on the web, go to:

http://groups.yahoo.com/group/diesel_mercedes/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:

http://groups.yahoo.com/group/diesel_mercedes/join

(Yahoo! ID required)

<*> To change settings via email:
mailto:diesel_mercedes-digest@yahoogroups.com
mailto:diesel_mercedes-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
diesel_mercedes-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:

http://docs.yahoo.com/info/terms/