Don't forget to buy more Electro - Contact Cleaner ! (hey you said to remind you)
Don't you love the simple solutions ? .
-Nate
Jim wrote :
>
> So a few minutes ago I pulled the wire plug from the side of the compressor and checked the voltage, which was over 12 volts when key turned to second notch (engine not started) and interior A/C control switch set to MAX. Then when I turned off the A/C control switch, key still ON, voltage went to 0. That's the way it is supposed to work AFAIK. However - the contacts looked really dirty...
>
> Next, I checked the gap on the clutch. It is a bit oversized I think, at .035. That didn't look good. But darnit, should be close enough, right?
>
> So I sprayed the contacts with Johnsen's electronic cleaner (I'm almost out of that, remind me to get more). Then I scraped the crud off them with a dental pick.
>
> Reinstalled wire plug to compressor.
>
> Freakin' thing WORKS.
>
> So that's the A/C Tutorial for the day LOL.
>
> Jim
>
>
>
>
>
>
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (5) |
No comments:
Post a Comment