Assuming you're working on a Becker....
There can be a multitude of plugs but the only one you really need is the four pin one with one pin slightly offset .
That offset pin it the 12 V + connection , typically black , it runs the radio .
The red wire is the always live 12 V + connection for the clock and preset memory .
The gray wire is the illumination wire , comes on with the dash lights .
The yellow wire it the power antenna signal wire ~ it kicks the antenna , _DO_NOT_ use it to _power_ and antenna ! .
The ground is connected to the radio's chassis and should be brown .
The speaker wire require cute little polarized plugs and will be green and black , Brian should be able to find you sone with 4" of leads .
The other plugs are for amplifiers used in W-126's .
I hope this helps ? .
-Nate
Lawrence wrote :
>
> Red wire to back of Becker then fuse then black wire then into the radio. A black wire goes out with the speaker wires. Brown ground. What do they all mean? Best guess is red 12 v. Black with speaker wires is antenna remote as turning on and off radio must be controlled. What else is in the grey bundle or is it just the speaker wires?
>
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (2) |
No comments:
Post a Comment