I complained to yahoo investor relations perhaps that will get more notice than just complaining here.
Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (1) |
This group provides a forum for owners and operators of diesel powered motorhomes and 5th wheel tractors to discuss mechanical issues, regulatory issues (US, Canada), ownership, insurance, campground accommodations, trip reports/suggestions, and other topics relevant to large RVs and the people who drive them.
I complained to yahoo investor relations perhaps that will get more notice than just complaining here.
Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (1) |
Welcome to the new member in Hot-lanta. Bill in
From:
Sent: Sunday, September 01, 2013 11:07 AM
To:
Subject: [diesel_mercedes] New Member
Greetings--Just a note of introduction. I've just joined this group and hope I can both contribute to and learn from the on-going discussion. Not yet a diesel owner, but I am enjoying my CLK320 Cabriolet while looking for a 300CD. Best Wishes--Carl
Carl G. Camann
Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (35) |
Greetings--Just a note of introduction. I've just joined this group and hope I can both contribute to and learn from the on-going discussion. Not yet a diesel owner, but I am enjoying my CLK320 Cabriolet while looking for a 300CD. Best Wishes--Carl
Carl G. Camann
Atlanta, Georgia
Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (34) |
The engine is now clean on one side, the manifolds are in along w/ the gutted CAT. I took apart this turbo, after making marks for later placement, and found gelled oil behind the impeller and throughout the housing, on the intake side, and built up carbon on the exhaust side, so obviously this turbo was leaking oil and needed a rebuild.
I'll put the turbo back together today and install.
I added some pics: engine, manifolds & CAT, turbo taken apart before cleaning intake & exhaust
album: Rob-'85 300D Garden Grove
http://groups.yahoo.com/group/diesel_mercedes/photos/album/326446776/pic/list
OK, back out to the garage.
Rob
'85 300D
Garden Grove, CA
ps: yes, drinking lots of water...
==
Re: exhaust & turbo repair today Posted by: "BStromsoe" bstromsoe@yahoo.com bstromsoe Date: Sat Aug 31, 2013 10:46 am ((PDT)) Go forth in victory, and drink lots of water. brian from laverne, ca Mary (195K) Martha (280K) 1983 w123 300d's ________________________________ From: Aleph93 <aleph93@ca.rr.com> To: diesel_mercedes@yahoogroups.com Sent: Saturday, August 31, 2013 8:56 AM Subject: [diesel_mercedes] exhaust & turbo repair today It's on to exhaust & turbo repair today, as earlier I found the whole exhaust system loose and/or broken. Be thankful that you don't have the '85 CA 300D w/ the CAT, as that extra part in the system, between the exhaust manifold and the turbo, allows more chance of movement of all the parts. Last week I tried to tighten up the system, and found the exhaust down pipe had sheared off, so I had that repaired, and while trying to tighten up the turbo mount, broke a bolt off in the manifold, which didn't want to come out with the usual drilling and 'easy-outs'. The shaking seemed about the same as before, yet I heard more noise from under the hood, and when I started pulling the turbo et al, I found a broken turbo bracket, and then the EGR tube, and later the end of the CAT had sheared too. When everything was pulled, I noticed many of the supports were loose. Luckily, I do have another set of parts I pulled from a parts car years ago, as well as a federal setup from Brian's old engine. Unfortunatly, the federal system won't fit w/ the '85 CA, A/C hose routes, yet if there's issues in the future I may switch out the A/C and exhaust system to the standard federal setup. Since it's all apart, it makes since to rebuild the turbo before reinstalling. Anyway, I better get out there before the heat rolls in. Rob '85 300D CA Garden Grove, CA
Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (3) |