Re: [diesel_mercedes] Re: I need some advice...

 

More is a relative term, like going from bad to badder.  Actually the worst damage is probably done by the pre-treatment salt spray that is more likely to really coat the underside of the car.  Brake and fuel lines are particularly likely to go away.  Once the car has been sprayed like that, it probably doesn't make much difference what temperature the car is stored at.  

About 3 years ago I bought an '87 560 SEL that had spent the greater part of its life in a heated garage in NJ.  What was developing was a rust spot on the drivers fender in front of the wheel and traced of  rust on the bottom of the front fenders where they met the rubber pads on top of the bumper.  No other significant rust was found.  The car had left its warm happy home about 2 years before I bought it, so I can't say whether the damage occurred during inside or outside storage.  On the other hand, I had an 83 SD that was always stored outside.  We drove it for a few years after we bought it, then about 5 years ago I did a lot of rust remediation on it including a fresh paint job.  About 6 months ago the rust on the front spring mounts and several other places got so bad that we had to take the car off the road.  This was at slightly over 400 M miles.

On Sat, Sep 12, 2015 at 4:06 PM, Max temple jasperezra@gmail.com [diesel_mercedes] <diesel_mercedes@yahoogroups.com> wrote:
 

If you keep a car in a garage in cold ice and snow country, its better to not have it heated. Why? Because the stuff put on roads to melt ice and snow is more active above freezing, and this stuff eats cars too. Max

On Fri, Sep 11, 2015 at 3:51 AM, wilck_ray@hotmail.com [diesel_mercedes] <diesel_mercedes@yahoogroups.com> wrote:


I am now considering selling the 1983 MB 300 CD.  Other than the issue of the front coil spring/shock absorber/suspension issue, the only problem is a radio that doesn't work.  There is an oil leak from the real seal, but it has been there for maybe 15 years.  No worse than then.  it uses a quart of oil about every 1,000-1,500 miles. There is some rust, but it is not bad. 175,000 actual miles.  Full service records. The car is in a heated garage near Detroit.  Any ballpark idea what this car is worth?  Is anyone interested in purchasing it?





--
Al Boucher

__._,_.___

Posted by: Alan Boucher <alsthe1@gmail.com>
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (9)

.

__,_._,___

Re: [diesel_mercedes] Re: I need some advice...

 

If you keep a car in a garage in cold ice and snow country, its better to not have it heated. Why? Because the stuff put on roads to melt ice and snow is more active above freezing, and this stuff eats cars too. Max

On Fri, Sep 11, 2015 at 3:51 AM, wilck_ray@hotmail.com [diesel_mercedes] <diesel_mercedes@yahoogroups.com> wrote:


I am now considering selling the 1983 MB 300 CD.  Other than the issue of the front coil spring/shock absorber/suspension issue, the only problem is a radio that doesn't work.  There is an oil leak from the real seal, but it has been there for maybe 15 years.  No worse than then.  it uses a quart of oil about every 1,000-1,500 miles. There is some rust, but it is not bad. 175,000 actual miles.  Full service records. The car is in a heated garage near Detroit.  Any ballpark idea what this car is worth?  Is anyone interested in purchasing it?


__._,_.___

Posted by: Max temple <jasperezra@gmail.com>
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (8)

.

__,_._,___

RE: RE: [diesel_mercedes] hub caps

 

You can lift the hubcap slightly anywhere to find the location of one post.

You don’t want to try to lift it tooo much or you can crease the lip of the hubcap

Lifting where a retaining post is puts the effort right where it is needed to remove the hubcap.  Bill in Oregon


From: diesel_mercedes@yahoogroups.com [mailto:diesel_mercedes@yahoogroups.com]
Sent: Saturday, September 12, 2015 11:08 AM
To: diesel_mercedes@yahoogroups.com
Subject: Re: RE: [diesel_mercedes] hub caps

 

 

How do I straddle the posts when I don't know where they are?

Sent from Yahoo Mail on Android


From:"corvallis@peoplepc.com [diesel_mercedes]" <diesel_mercedes@yahoogroups.com>
Date:Sat, Sep 12, 2015 at 12:51 PM
Subject:RE: [diesel_mercedes] hub caps

There are three button posts under there. I use a claw hammer and a thin block of wood.

The wood goes between the hammer and the painted wheel.

Like pulling a nail with just the tips of the claw end of the hammer under the underside of the hubcap but straddling the post underneath.

Sometimes the one you’re working on will only pull half way over the nubbin.

Go onto the next one and the hubcap will come off. Bill (1961 190Db)


From: diesel_mercedes@yahoogroups.com [mailto: diesel_mercedes@yahoogroups.com ]
Sent: Saturday, September 12, 2015 10:24 AM
To: diesel_mercedes@yahoogroups.com
Subject: [diesel_mercedes] hub caps

 

How can I safely remove my hubcaps from my 1965 mercedes 190 without bending them or damaging them?

Thank you
Laura

__._,_.___

Posted by: <corvallis@peoplepc.com>
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (4)

.

__,_._,___

Re: RE: [diesel_mercedes] hub caps

 


How do I straddle the posts when I don't know where they are?

Sent from Yahoo Mail on Android


From:"corvallis@peoplepc.com [diesel_mercedes]" <diesel_mercedes@yahoogroups.com>
Date:Sat, Sep 12, 2015 at 12:51 PM
Subject:RE: [diesel_mercedes] hub caps

 

There are three button posts under there. I use a claw hammer and a thin block of wood.

The wood goes between the hammer and the painted wheel.

Like pulling a nail with just the tips of the claw end of the hammer under the underside of the hubcap but straddling the post underneath.

Sometimes the one you're working on will only pull half way over the nubbin.

Go onto the next one and the hubcap will come off. Bill (1961 190Db)


From: diesel_mercedes@yahoogroups.com [mailto: diesel_mercedes@yahoogroups.com ]
Sent: Saturday, September 12, 2015 10:24 AM
To: diesel_mercedes@yahoogroups.com
Subject: [diesel_mercedes] hub caps

 

How can I safely remove my hubcaps from my 1965 mercedes 190 without bending them or damaging them?

Thank you
Laura

__._,_.___

Posted by: Laura Bilecki <sarrcho@yahoo.com>
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (3)

.

__,_._,___

RE: [diesel_mercedes] hub caps

 

There are three button posts under there. I use a claw hammer and a thin block of wood.

The wood goes between the hammer and the painted wheel.

Like pulling a nail with just the tips of the claw end of the hammer under the underside of the hubcap but straddling the post underneath.

Sometimes the one you’re working on will only pull half way over the nubbin.

Go onto the next one and the hubcap will come off. Bill (1961 190Db)


From: diesel_mercedes@yahoogroups.com [mailto:diesel_mercedes@yahoogroups.com]
Sent: Saturday, September 12, 2015 10:24 AM
To: diesel_mercedes@yahoogroups.com
Subject: [diesel_mercedes] hub caps

 

How can I safely remove my hubcaps from my 1965 mercedes 190 without bending them or damaging them?

Thank you
Laura

__._,_.___

Posted by: <corvallis@peoplepc.com>
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (2)

.

__,_._,___

[diesel_mercedes] hub caps

 

How can I safely remove my hubcaps from my 1965 mercedes 190 without bending them or damaging them?

Thank you
Laura

__._,_.___

Posted by: sarrcho@yahoo.com
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (1)

.

__,_._,___

[diesel_mercedes] September Shock Sales Events

 



On Friday, September 11, 2015 3:00 PM, Shockwarehouse <ross@shockwarehouse.com> wrote:


September Sales Events

September Sales Events!

KYB Price Drop and $20 Rebate
 

Our lowest KYB Prices Ever!  

PLUS Every Order Over $150 Gets a $20 Visa Gift Card!

Monroe Buy 3 Get 1 Free Rebate
 
Buy 4 Monroe or Rancho shocks and get a Visa gift card for the value of one of the shocks!

 

Our Lowest Monroe Prices Ever!

Copyright © 2015 Shockwarehouse, All rights reserved.
We send special deals to customers who purchased shocks from Shockwarehouse.com

Our mailing address is:
Shockwarehouse
3433 NE 12 Terrace
Oakland Park, FL 33334

Add us to your address book


Want to change how you receive these emails?
You can update your preferences or unsubscribe from this list

Email Marketing Powered by MailChimp


__._,_.___

Posted by: Nate <vwnate1@yahoo.com>
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (1)

.

__,_._,___