Sent from my iPhone
On Aug 11, 2016, at 10:43 PM, Bogy Wan Kenobi polespearbogy@yahoo.com [diesel_mercedes] <diesel_mercedes@yahoogroups.com> wrote:
Guys: here is a pic of my latest injector tester. I will be putting it on a new jack as the solvents i have run through this one to clean the injectors has ruined the seals. The s shaped piece with the gauge is deliberate. It doesnt drain between uses and there is no air bleeding before making the next test. All the air quickly is expelled within a few pumps and it can be screwed onto an IP delivery pipe to check for check valve operation /failure.
BTW, My engine loping was finally eliminated by replacing the check valve in the #4 outlet pipe. It was pitted at the contact surface and loosing pressure between squirts when the engine warmed up.
For your viewing pleasure I have included a pic of the culprit.
Enjoy, and thanks again for your help in the debugging of my engine.
Bogy.
"Hardware eventually fails.
Software eventually works"
- Michael Hartung
-
Posted by: Greg Arrambide <rio78840@yahoo.com>
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (1) |
No comments:
Post a Comment