Stan, it's made of two pieces. The inside part (the stud) is a pin with a head that sits above (or, in this case, below) the outside part (the "washer"). You need to get under the head of that pin with a screwdriver or a knife, and pull it from the outside piece. When you get the inside piece about 1/4-inch or so out, the whole thing will draw out.
From: "Stan George" <ssgkag@frontier.com>
To: "diesel mercedes" <diesel_mercedes@yahoogroups.com>
Sent: Saturday, December 3, 2011 2:22:03 PM
Subject: [diesel_mercedes] vacuum reservoir
Mark in Lakewood, CO
From: "Stan George" <ssgkag@frontier.com>
To: "diesel mercedes" <diesel_mercedes@yahoogroups.com>
Sent: Saturday, December 3, 2011 2:22:03 PM
Subject: [diesel_mercedes] vacuum reservoir
How do you remove the vacuum reservoir from under the rear glass? It
appears to be held in place by a stud with a washer on it but it is not
a screw head.
--
Stan George Portland <<
__._,_.___
MARKETPLACE
.
__,_._,___
No comments:
Post a Comment