Can you cut the nut with a Dremel tool? I use an extension cable and 1-inch diameter cut-off disks.
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=261703428540
I keep my small disks that are almost used up for small, close in problems. Bill in
From:
Sent: Wednesday, December 17, 2014 4:01 PM
To:
Subject:
. . . . Three 10mm nuts on studs, first two twist off fine, third, I could tell by 40 years of experience it is gonna snap. I probably already went too far, but screwed it back in place, did not snap. What should I do? What can be done if it breaks? I can tell its gonna break if I try and unscrew the nut. I opted to clean out the air filter housing in place, but then went for the ill fated 4-wheeler ride, crashed, had to crawl home, lay on the couch till today. Car will wait, cant drive it anyway now, just getting it ready for spring. I probably should live in Temucala or some warm place like that, maybe a avocado ranch in
Posted by: <corvallis@peoplepc.com>
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (28) |
No comments:
Post a Comment