On 2/23/2013 11:02 AM, Roland Hyatt wrote:
>
> The glow plug "reamers" tend to be expensive. What would you suggest as
> a "fashioned" substitute?
Being careful of the threaded portion of the hole, I've used very stiff
wire with a slight bend at the end to rotate in the port. Also have
taken an old "pencil type" glow plug and flattened the element portion
to where it is slightly wider than the actual element then ground a
sharp knife edge on it. Haven't used that yet but it should scrape some
carbon loose if there is any.
--
Stan George Portland <<
__._,_.___
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (69) |
.
__,_._,___
No comments:
Post a Comment